|
|
‛‛OneWrench” User Instructions
|
|
|
|
‛‛Adjust 750 & 1850 Grain Drill depth using only One hand and One wrench” |
|
|
|
‛‛OneWrench” User Instructions :
Video |
|
|
|
Step 1: Holding OneWrench at a 30 degree angle to the John Deere adjusting plate,
insert the square alignment point into the square hole on the adjusting plate
until the 1/8” roll pin stop contacts the plate. |
|
|
|
Step 2: Next, while watching that the OneWrench pads are in alignment with the
slots in the adjusting plate, press the handle towards the adjusting plate until
the locking pin is released and OneWrench support plate is securely against the
adjusting plate. |
|
|
|
Step 3: While continuing to press the OneWrench handle against the adjusting plate,
rotate the OneWrench handle and adjusting plate to your desired setting.
|
|
|
|
Step 4: Next, move the handle away from the adjusting plate until the pads are free, but still within 1/4” of the adjusting plate. If the locking pin is between two slots and does not engage a slot, rotate the handle, thereby rotating the adjusting plate until the locking pins snaps into the slot you want. If the adjusting plate is abnormally tight, it is recommended you do not force it with
OneWrench in this position. Rather, re-engage OneWrench pads in the adjusting plate slots and locate the slot directly over the locking pin before releasing.
|
|
|
|
Step 5: Move the OneWrench handle to a 30 degree angle with the adjusting plate, and
remove the alignment point and OneWrench.
|
|
